The high-pressure probe mount TM0393X, works with Provibtech’s TM0180 and TM0110 reverse mount for easy installation. The housing is made of aluminum (copper free) and stainless steel which sustain harsh environments. The high-pressure probe mount, TM0393X, can be used for up to 2000psi (15Mpa)

The high-pressure extension cable feed through can be used in pressurized machine areas. The hi-pressure extension cable feed through is sealed for up to 150 psi (1.0 Mpa). There are three versions of the high-pressure feed through (single, dual and triple cables) which allows for a maximum of three cables to pass through the machine case. The high-pressure end is supplied with female connectors and the low-pressure end with male connectors.

1. TM0903: Junction Box
2. TM0902: Low-Pressure Cable Seal
3. Probe
4. TM0906: Probe Bracket
5. TM0904 Flexible Conduit/ PT500-19 Cable Seal/ PT500-18 Seal
6. TM0920-BOOT: Connector Protector
7. Machine Case

TM0540 is specially designed for proximity probe static calibration. It is designed to calibrate 5mm, 8mm, 11mm and 25mm proximity probe systems.

TM0540 is quite easy to use. Just connector the proximity probe with power supply and a volt-meter. Measure the probe gap vs. probe driver output voltage. The linearity and sensitivity can then be calculated accordingly.

The TM0920 supplies 10 sets of proximity probe connector boots. The connector boots protect the connection between the proximity probes and extension cables from oil and dirt penetration (which is a leading cause of inaccurate proximity probe readings) as well as preventing ground loops by isolating the probe from the machine case. The TM0920 connector protection kit provides customers with an easy way of mounting connector protectors in the field. Note: ProvibTech’s probes and extension cables come standard with connector protectors.

PT520 shaker is a portable calibration device. It is capable of calibrating the adynamic calibration of accelerometers, velocity sensors, vibration transmitters, and proximity probes in laboratory or in the field. PT520 has a built-in electro-magnetic shaking head that will generate vibration. The vibration can be digitally turned in acceleration, velocity or displacement with RMS, peak, or peak-peak. It can display in English or Metric unit. In addition, PT520 can supply sensor power, receive the output from the sensor and compare the sensor output vs. the standard output to obtain the standard calibration curve.

TM0520-K portable vibration shaker is designed to be used in the field or shop to verify the performance of vibration transducers, connectors, cabling, instruments or permanently installed condition monitoring systems. Both models are battery-powered, portable and feature a built-in reference accelerometer and indicator with calibration traceable to the National Institute of Standards and Technology (NIST).
Copyright © Provib Tech.com. . All Rights Reserved